
Heating Service in Athens, Alabama
Heating Repair in Athens, Alabama
Furnace and heat pump repair for Athens and Limestone County homeowners dealing with no heat, cold air from the vents, a system that won’t start, constant running, or uneven temperatures.
Licensed & Insured • Based in Athens • Serving Athens and Limestone County
Local Heating Repair
Heating Repair From an Athens-Based HVAC Company
Gatlin’s Heating & Cooling is based right here in Athens, so when your heat goes out, you’re calling a local team, not a company driving in from across the county. We repair gas furnaces, electric furnaces, heat pumps, air handlers, and thermostats for homes throughout Athens and Limestone County.
Athens-area homes run on a mix of heating systems, from gas furnaces in town to all-electric heat pumps and electric furnaces on properties without gas service. Our technicians work on all of them, and we start every visit by finding the actual cause of the problem instead of guessing from the symptom.
If your system is blowing cool air, won’t turn on, keeps cycling, or can’t keep the house warm, send a service request or give us a call. For an overview of every heating system we install and repair, see our main heating repair and installation page.
Request Heating Repair
No heat or weak heat
Gas and electric furnace repair
Heat pump heating problems
Thermostat troubleshooting
Homes and light commercial buildings
Send a Service RequestBased in Athens
Our shop is in Athens, and we serve homes and businesses throughout Limestone County and the surrounding area.
Every System Type
Gas furnaces, electric furnaces, heat pumps, and dual-fuel systems are all repaired by the same experienced team.
Honest Recommendations
We explain what we found and what it will cost before any work begins, and we never push a replacement when a repair will do.
Common Heating Problems
Heating Problems We Repair in Athens
Most heating systems give warning signs before they quit completely. Weaker heat, louder operation, longer run times, or a higher power or gas bill are all worth a call. Catching a problem early is usually faster and less expensive than an emergency repair on the coldest night of the year.
01
No Heat at All
A system that won’t start may have a failed igniter, flame sensor, control board, capacitor, breaker, or thermostat problem.
02
Cool or Lukewarm Air
Air that never gets warm can point to burner or ignition issues on a furnace, or defrost, refrigerant, or auxiliary heat issues on a heat pump.
03
Furnace Starts, Then Shuts Off
Short cycling often comes from a dirty flame sensor, overheating from restricted airflow, or a safety control shutting the system down.
04
Runs Constantly Without Warming
A system that never reaches the thermostat setting may be losing capacity, short on airflow, or leaning on backup heat to keep up.
05
Strange Noises or Smells
Banging, squealing, grinding, or a burning or electrical smell should be checked right away before it becomes a bigger problem.
06
Cold Rooms and Hot Rooms
Uneven temperatures can come from duct problems, blower issues, thermostat placement, or a system that isn’t sized correctly for the home.

How a Repair Visit Works
Our Athens Heating Repair Process
A good repair starts with a correct diagnosis. Our technicians test how the whole system is operating, so the fix addresses the cause and not just the symptom you noticed.
Listen to What’s Happening
We ask what the system is doing, when it started, and whether anything has changed recently.
Test the Equipment
The technician checks ignition, burners or heat strips, electrical components, controls, airflow, and the thermostat.
Walk You Through It
We explain the problem, your repair options, and the cost before any work is done.
Repair and Confirm Heat
Once approved, we complete the repair and run the system to confirm it’s heating the home properly.
Repair or Replace?
Should You Repair or Replace Your Heating System?
Most heating problems are repairable. When the system is in good overall shape and the failure is isolated, such as an igniter, capacitor, or control board, a repair is usually the right call.
When a system is older, needs repairs every season, or has a major component failure like a cracked heat exchanger or failed compressor, it may be time to compare repair cost against replacement. We’ll give you straight numbers on both so you can decide.
View All Athens HVAC Services Replacement May Be Worth Discussing When:
The system needs repairs every heating season
The home never feels evenly warm
A heat exchanger, compressor, or other major part has failed
The repair cost is high compared to the system’s value
The equipment is 15 or more years old
Explore HVAC FinancingHeating Systems
Heating Systems We Repair in Athens
Whatever heats your home, our technicians have the experience to diagnose and repair it.
Gas Furnaces
Repair for igniters, flame sensors, burners, gas valves, inducer and blower motors, and safety controls.
Electric Furnaces & Air Handlers
Repair for heat strips, sequencers, relays, blower motors, and controls in all-electric homes.
Heat Pumps
Heating-mode repair for defrost, reversing valve, refrigerant, and auxiliary heat problems. See heat pump services in Athens.
Thermostats & Controls
Troubleshooting thermostat settings, wiring, control communication, and calls for heat that aren’t reaching the system.
Serving Athens, Alabama
Heating Repair Throughout Athens and Limestone County
From historic homes near downtown Athens to newer subdivisions and rural properties across Limestone County, Gatlin’s Heating & Cooling provides heating repair close to home. We also serve light commercial properties in the Athens area.
We serve Madison and nearby communities too. Homeowners there can visit our Madison heating repair page. Service availability may vary based on location, scheduling, and the type of HVAC work requested.
Downtown Athens
Canebrake
US Highway 72
Lindsay Lane
Tanner
Elkmont
East Limestone
Ardmore
Why Choose Gatlin’s?
Athens Heating Repair You Can Count On
Local to Athens
We’re based in Athens and know the homes, systems, and winter weather our neighbors deal with.
Licensed and Insured
All heating repairs are completed by a properly licensed and insured local HVAC contractor.
Repair Before Replace
We look for a practical repair first and only discuss replacement when it truly makes more sense.
Complete HVAC Support
Heating repair plus AC repair, maintenance, system replacement, and emergency service from one local company.
Athens Heating Repair FAQ
Heating Repair Questions From Athens Homeowners
Why is my heater running but the house won’t warm up?
The cause could be a dirty filter, a blower or airflow problem, an ignition or burner issue on a furnace, or a defrost, refrigerant, or auxiliary heat issue on a heat pump. A technician needs to test the system to find the specific cause.
Why does my furnace turn on and then shut off?
This is often caused by a dirty flame sensor, overheating from restricted airflow, a failing limit switch, or another safety control shutting the furnace down. Repeated shutdowns should be diagnosed rather than reset over and over.
Do you repair electric furnaces and heat pumps in homes without gas?
Yes. Many homes around Athens and Limestone County are all-electric, and we regularly repair electric furnaces, air handlers, heat strips, and heat pumps.
What should I check before calling for heating repair?
Make sure the thermostat is set to heat and the setting is above room temperature, replace the air filter if it’s dirty, and check that the breaker for the system hasn’t tripped. If the heat still isn’t working, schedule service.
Do you serve areas outside Athens city limits?
Yes. We provide heating repair throughout Limestone County, including Tanner, Elkmont, Ardmore, and East Limestone, as well as Madison and nearby communities.
How do I request heating repair in Athens?
Use the online service request form or call 256.651.5009. Include your address, how urgent the problem is, and what the system is doing, and our team will contact you to schedule.

